Netgear Netgear DGN3500: Restore Factory Defaults

Discus and support Netgear Netgear DGN3500: Restore Factory Defaults in XboX Networking Hardware to solve the problem; Netgear (Modems/Gateways) Netgear DGN3500: Restore Factory Defaults Login Information Gateway - 192.168.0.1 Username - admin Password - password... Discussion in 'XboX Networking Hardware' started by XB1R Hades, Jul 25, 2014.

  1. XB1R Hades
    XB1R Hades Guest

    Netgear Netgear DGN3500: Restore Factory Defaults


    Netgear (Modems/Gateways) Netgear DGN3500: Restore Factory Defaults
    Login Information

    • Gateway - 192.168.0.1
    • Username - admin
    • Password - password
    Restore Factory Defaults

    Through firmware

    1. Plug the computer into a LAN port via an ethernet cable.
    2. Login to router by entering http://routerlogin.net in to the address bar or by entering the default gateway IP address.
    3. The router will then prompt you to enter the user name and password. the default user name and password are: "admin", "password".
    4. From the left hand menu select Backup Settings.
    5. Select the Erase option under where it says Revert to factory default settings.
    Through Hardware

    1. Plug the computer into a LAN port via an ethernet cable.
    2. Locate the reset button on the device.
    3. With paperclip/pen/toothpick hold down the reset button down for 30 seconds.
    4. Wait for lights to turn off then return to normal.

    :)
     
    XB1R Hades, Jul 25, 2014
    #1
  2. XB1R Athena
    XB1R Athena Guest
    Netgear: Restore Factory Defaults

    Netgear (Routers): Restore Factory Defaults
    Login Information

    • Gateway - 192.168.1.1, 10.0.0.1, or routerlogin.net
    • Username – admin
    • Password – password

    Netgear - Smart Wizard- Light Blue



    Restoring Defaults

    Through firmware

    1. Plug the computer into a LAN port via an ethernet cable.
    2. Login to router by entering
      http://routerlogin.net
      in to the address bar or by entering the default gateway IP address.
    3. The router will then prompt you to enter the user name and password.the default user name and password are: "admin", "password".
    4. From the left hand menu select Backup Settings.
    5. Select the Erase option under where it says Revert to factory default settings.
    Through Hardware

    1. Plug the computer into a LAN port via an ethernet cable.
    2. Locate the reset button on the device.
    3. With paperclip/pen/toothpick hold down the reset button down for 30 seconds.
    4. Wait for lights to turn off then return to normal.
    Netgear - Genie - Black/Purple



    Restoring Defaults

    Through firmware

    1. Plug the computer into a LAN port via an ethernet cable.
    2. Login to router by entering
      http://routerlogin.net
      in to the address bar or by entering the default gateway IP address.
    3. The router will then prompt you to enter the username and password.

      the default user name and password are: "admin", "password".
    4. Select the Advanced tab from the tabs at the top.
    5. Select Administration from menu on the left.
    6. From the submenu select Backup Settings.
    7. Select the Erase option under where it says Revert to factory default settings.
    Through Hardware

    1. Plug the computer into a LAN port via an ethernet cable.
    2. Locate the reset button on the device.
    3. With paperclip/pen/toothpick hold down the reset button down for 30 seconds.
    4. Wait for lights to turn off then return to normal.
     
    XB1R Athena, Jul 25, 2014
    #2
  3. XB1R Apollo
    XB1R Apollo Guest
    Netgear: Restore Factory Defaults

    Netgear (Routers): Restore Factory Defaults
    Login Information

    • Gateway - 192.168.0.1 (v1-v5) or 192.168.1.1 (v6-v10)
    • Username - admin
    • Password - password

    Restore Factory Defaults

    Through firmware

    1. Plug the computer into a LAN port via an ethernet cable.
    2. Login to router by entering
      http://routerlogin.net
      in to the address bar or by entering the default gateway IP address.
    3. The router will then prompt you to enter the user name and password.the default user name and password are: "admin", "password".
    4. From the left hand menu select Backup Settings.
    5. Select the Erase option under where it says Revert to factory default settings.
    Through Hardware

    1. Plug the computer into a LAN port via an ethernet cable.
    2. Locate the reset button on the device.
    3. With paperclip/pen/toothpick hold down the reset button down for 30 seconds.
    4. Wait for lights to turn off then return to normal.
     
    XB1R Apollo, Jul 25, 2014
    #3
  4. Wo0dsiE Win User

    Netgear: Restoring Defaults

    The only thing that worked for me when I started having connect to xboxlive problems is restoring factory defaults on my router. I did it the easy way, I reset used the reset button in the back. (press it with a paper clip until the power button starts blinking...
    only took mine less than five seconds) the router does the rest. Make sure you set the wireless security back to WPA2 (strongest). Then create your password. I'm back playing ghosts again with no issues. Not sure how it got out of whack and I was ready to
    go buy a new one, but all is good now.
  5. taidara Win User

    New xbox slim - no wireless networks found

    Greetings Bunny Assassins!

    Have you tried to restore (reset) the Netgear power adapters back to factory defaults and then pair them up again?
  6. ArminatorX Win User

    Netgear DGN3500: Netgear LB2120 UPnP Unavailable

    I'm a bit confused about what you mean by "this device is linked to an actual router".

    From the specifications, the LB2120 takes a wired WAN (e.g. from a DSL or cable modem), and also supports 4G cellphone based connections.

    Such a setup is fine for fault tolerance or speed boosts, if the 4G network is significantly faster than your DSL or cable connection.

    However: most internet providers don't have enough IPv4 adresses for cellphone connections, and therefore use CG-NAT and tunneling techniques like DS-Lite to tunnel IPv4 through an IPv6 address. So multiplayer via cellphone connections hardly work properly.

    As for your Nexxt Solutions router: If that really is a router, and not just a cable modem, then you have a double NAT, as the Nexxt router and your LB2120 are both NAT devices.

    And, to top it off, your ISP might also do CG-NAT on your cable/DSL connection, which would give you a triple NAT.

    Is there a specific reason to why you need the LB2012 for your Xbox? If it's about the "speed" you'd get from the 4G connection, you can use that speed only for downloading games faster. It will not help you for multiplayer or Party chat connections.

    If possible, connect your Xbox as "close" as possible to the internet connection with as few devices between the console and internet. Which means to plug it into the Nexxt Solutions router.

    When on the router, use your PC to sign into it's configuration page, and take a note of the Nexxt Solutions WAN IP address (i.e. the IP you get from your internet provider). Then surf to a page like https://www.whatismyip.com/ and
    make a note of the "Your Public IP" address. If the public IP from the page and the WAN IP on your Nexxt Solutions router are different, your ISP is using CG-NAT and you need to contact him to ask for a proper public IPv4 Address that is not NATed.
  7. GMAN990 Win User

    Can't connect anymore!

  8. BiggsHD Win User

    My friend can't hear me on xbox live anymore.

    @zanswerlive @taidara - I've just come back from his house, we've both restored our routers to factory settings. My mate has a Netgear CG3100 and I've got a Netgear C6300

    I've also got 2 xbox 360 consoles that connect to the same router but has never been a problem
Thema:

Netgear Netgear DGN3500: Restore Factory Defaults

Loading...
  1. Netgear Netgear DGN3500: Restore Factory Defaults - Similar Threads - Netgear Netgear DGN3500

  2. Netgear DGN3500: Netgear LB2120 UPnP Unavailable

    in XboX Networking Hardware
    Netgear DGN3500: Netgear LB2120 UPnP Unavailable: Netgear DGN3500: Netgear LB2120 UPnP Unavailable I'm a bit confused about what you mean by "this device is linked to an actual router". From the specifications, the LB2120 takes a wired WAN...
  3. Netgear Netgear DGN3500: IPv6

    in XboX Networking Hardware
    Netgear Netgear DGN3500: IPv6: Netgear (Modems/Gateways) Netgear DGN3500: IPv6 Does my router supports IPv6. 35a8b4ea-c96c-4200-96d0-564e7433c767
  4. Netgear Netgear DGN3500: Known Issues

    in XboX Networking Hardware
    Netgear Netgear DGN3500: Known Issues: Netgear (Modems/Gateways) Netgear DGN3500: Known Issues Login Information Gateway - 192.168.0.1 Username - admin Password - password Known Issues There are no known issues with this device....
  5. Netgear Netgear DGN3500: Entering PPPoE

    in XboX Networking Hardware
    Netgear Netgear DGN3500: Entering PPPoE: Netgear (Modems/Gateways) Netgear DGN3500: Entering PPPoE Login Information Gateway - 192.168.0.1 Username - admin Password - password Entering PPPoE Plug the computer into a LAN port via...
  6. Netgear Netgear DGN3500: Firmware Update

    in XboX Networking Hardware
    Netgear Netgear DGN3500: Firmware Update: Netgear (Modems/Gateways) Netgear DGN3500: Firmware Update Login Information Gateway - 192.168.0.1 Username - admin Password - password Firmware Update Auto Update Plug the computer into...
  7. Netgear Netgear DGN3500: How to Find Firmware Version

    in XboX Networking Hardware
    Netgear Netgear DGN3500: How to Find Firmware Version: Netgear (Modems/Gateways) Netgear DGN3500: How to Find Firmware Version Login Information Gateway - 192.168.0.1 Username - admin Password - password How to Find Firmware Version Plug...
  8. Netgear Netgear DGN3500: Firewall

    in XboX Networking Hardware
    Netgear Netgear DGN3500: Firewall: Netgear (Modems/Gateways) Netgear DGN3500: Firewall Login Information Gateway - 192.168.0.1 Username - admin Password - password Firewall Login to router by entering http://routerlogin.net...
  9. Netgear Netgear DGN3500: Port Forwarding

    in XboX Networking Hardware
    Netgear Netgear DGN3500: Port Forwarding: Netgear (Modems/Gateways) Netgear DGN3500: Port Forwarding Login Information Gateway - 192.168.0.1 Username - admin Password - password Port Forwarding Login to router by entering...
  10. Netgear Netgear DGN3500: DMZ

    in XboX Networking Hardware
    Netgear Netgear DGN3500: DMZ: Netgear (Modems/Gateways) Netgear DGN3500: DMZ Login Information Gateway - 192.168.0.1 Username - admin Password - password DMZ Login to router by entering http://routerlogin.net in to...