Zyxel Zyxel Prestige 841: Overview

Discus and support Zyxel Zyxel Prestige 841: Overview in XboX Networking Hardware to solve the problem; Zyxel (Modems/Gateways) Zyxel Prestige 841: Overview Login Information To login and configure the P-841 you will need a computer with terminal... Discussion in 'XboX Networking Hardware' started by XB1R Hydros, Jul 10, 2014.

  1. XB1R Hydros
    XB1R Hydros Guest

    Zyxel Zyxel Prestige 841: Overview


    Zyxel (Modems/Gateways) Zyxel Prestige 841: Overview
    Login Information

    To login and configure the P-841 you will need a computer with terminal emulation software configured. You will also need to use Command Line to configure the device as stated in the user manual. It is suggested that you replace this device by contacting
    your Internet Service Provider (ISP).

    • Username: none
    • Password: 1234


    How to Find SSID (Network Name)

    This device does not have this feature.



    How To Find Wireless Passphrase (WPA/WEP)

    This device does not have this feature.



    Changing Wireless Security Type/ Disabling Wireless Security

    This device does not have this feature.



    MAC Filtering

    This device does not have this feature.



    Disable MAC Filtering

    This device does not have this feature.



    Change Wireless Channel

    This device does not have this feature.



    Change Wireless Mode

    This device does not have this feature.



    Change Wireless Band (Width)

    There is no option to change the wireless band width.



    DHCP Reservation

    This device does not have this feature.



    UPnP

    This device does not have this feature.



    DMZ

    This device does not have this feature.



    Disable DMZ

    This device does not have this feature.



    Port Forwarding

    This device does not have this feature.



    Disable Port Forwarding

    This device does not have this feature.



    Firewall

    This device does not have this feature.



    How to Find Firmware Version

    This device does not have this feature.



    Firmware Update

    Contact your ISP for assistance in updating the firmware on this device.



    Restore Factory Defaults

    The Following instruction will reset the device you may need to contact you ISP


    From Hardware:

    1. Locate the back of the device, where the Ethernet port are located.
    2. Hold the reset button on the back for 30 seconds. You will need a paperclip, toothpick or pen to hold down the reset button.
    3. Let go of the reset button and wait about 1 minute for the device to reboot.


    From Firmware:

    This device does not have this feature.



    Entering PPPoE

    This device does not have this feature.



    Known Issues

    There are no currently known issues with this device.



    Multiple console Support

    We have confirmed that this network device is unable to support more than one console with an Open NAT.



    Device Manual

    Device Manual can be found here: ftp://ftp.zyxel.com/P-841/user_guide/P-841_841-25_v1.pdf (please copy paste this into your web browser).

    :)
     
    XB1R Hydros, Jul 10, 2014
    #1
  2. XBIR Zeus
    XBIR Zeus Guest
    Zyxel Zyxel Prestige 841: Device Manual

    Zyxel (Modems/Gateways) Zyxel Prestige 841: Device Manual
    Zyxel Prestige 841

    Device Manual can be found here: ftp://ftp.zyxel.com/P-841/user_guide/P-841_841-25_v1.pdf (please copy paste this into your web browser).
     
    XBIR Zeus, Jul 10, 2014
    #2
  3. XB1R Hydros
    XB1R Hydros Guest
    Zyxel Zyxel Prestige 841: Known Issues

    Zyxel (Modems/Gateways) Zyxel Prestige 841: Known Issues
    Known Issues

    There are no currently known issues with this device.
     
    XB1R Hydros, Jul 10, 2014
    #3
  4. XB1R Triton Win User

    Zyxel Zyxel PK5000z: Overview

    Test Post, this is the bomb
  5. DevonSwitzer Win User

    Zyxel Zyxel VSG1432: Overview

    How do I view my MTU settings on this router? I'm getting MTU error when I test connection on Xbox 360.
  6. Dênis=X-RAY= Win User

    Zyxel Zyxel 660 Series: Overview

    My modem is a Zyxel P-660-T1, I am trying to connect my xboxone via cable, but always appears a message:. "DNS is not identifying the names of the Xbox servers The router or modem may not be providing your DNS settings . adjust these settings for a static
    DNS. "

    CAN SOMEONE HELP ME?
  7. jmcode Win User

    Double NAT problems (I Think)

    Yes, the Zyxel is a gateway (modem+router), and you have problematic double NAT as a result. If you have access to the right settings, you can put the Zyxel in bridge mode as explained on page 22 of the manual here:

    ftp.zyxel.com/.../P-660RU-T1%20v3s_1.01.pdf

    This is the best solution, but your ISP may block those settings. If it does, and if it is unwilling to set it to bridge mode for you, another option is to disable DHCP on the Belkin and connect the Zyxel to a LAN port on the Belkin rather than WAN. Reboot
    Zyxel, Belkin, Xbox, and Xbox should get an IP from the Zyxel via DHCP (reserve this IP if the Zyxel supports that). You will then need to do all necessary port forwarding to the Xbox using the Zyxel unless the Zyxel properly implements UPnP (in which case
    enable that).
  8. jmcode Win User

    Double NAT problems (I Think)

    Just to be clear, when you disabled DHCP on the Belkin, did you then connect the Zyxel to a LAN port on the Belkin? Did you verify the IP you used for port forwarding on the Zyxel was the new IP the Xbox One got from the Zyxel, not the one it had from the
    Belkin? If so, that should work unless something else is going on--can you get open NAT with the Xbox One directly wired to the Zyxel (with ports forwarded)? If not, that is a problem.

    As far as settings for bridge mode, I'm not familiar with your ISP so I'm not sue which setting is best on the Zyxel. On the Belkin, you need to match the current ISP setting on the Zyxel--i.e. if Zyxel is using PPPoE, set the Belkin to that. You will probably
    need to enter authentication (user/pass) depending on what that setting is...
Thema:

Zyxel Zyxel Prestige 841: Overview

Loading...
  1. Zyxel Zyxel Prestige 841: Overview - Similar Threads - Zyxel Zyxel Prestige

  2. Zyxel Zyxel Prestige 841: How to Find SSID

    in XboX Networking Hardware
    Zyxel Zyxel Prestige 841: How to Find SSID: Zyxel (Modems/Gateways) Zyxel Prestige 841: How to Find SSID (Network Name) Login Information To login and configure the P-841 you will need a computer with terminal emulation software...
  3. Zyxel Zyxel Prestige 841: Wireless Security

    in XboX Networking Hardware
    Zyxel Zyxel Prestige 841: Wireless Security: Zyxel (Modems/Gateways) Zyxel Prestige 841: Wireless Security Login Information To login and configure the P-841 you will need a computer with terminal emulation software configured. You will...
  4. Zyxel Zyxel Prestige 841: MAC Filtering

    in XboX Networking Hardware
    Zyxel Zyxel Prestige 841: MAC Filtering: Zyxel (Modems/Gateways) Zyxel Prestige 841: MAC Filtering Login Information To login and configure the P-841 you will need a computer with terminal emulation software configured. You will also...
  5. Zyxel Zyxel Prestige 841: Change Wireless Channel

    in XboX Networking Hardware
    Zyxel Zyxel Prestige 841: Change Wireless Channel: Zyxel (Modems/Gateways) Zyxel Prestige 841: Change Wireless Channel Login Information To login and configure the P-841 you will need a computer with terminal emulation software configured. You...
  6. Zyxel Zyxel Prestige 841: Change Wireless Mode

    in XboX Networking Hardware
    Zyxel Zyxel Prestige 841: Change Wireless Mode: Zyxel (Modems/Gateways) Zyxel Prestige 841: Change Wireless Mode Login Information To login and configure the P-841 you will need a computer with terminal emulation software configured. You will...
  7. Zyxel Zyxel Prestige 841: DHCP Reservation

    in XboX Networking Hardware
    Zyxel Zyxel Prestige 841: DHCP Reservation: Zyxel (Modems/Gateways) Zyxel Prestige 841: DHCP Reservation Login Information To login and configure the P-841 you will need a computer with terminal emulation software configured. You will also...
  8. Zyxel Zyxel Prestige 841: UPnP

    in XboX Networking Hardware
    Zyxel Zyxel Prestige 841: UPnP: Zyxel (Modems/Gateways) Zyxel Prestige 841: UPnP Login Information To login and configure the P-841 you will need a computer with terminal emulation software configured. You will also need to use...
  9. Zyxel Zyxel Prestige 841: DMZ

    in XboX Networking Hardware
    Zyxel Zyxel Prestige 841: DMZ: Zyxel (Modems/Gateways) Zyxel Prestige 841: DMZ Login Information To login and configure the P-841 you will need a computer with terminal emulation software configured. You will also need to use...
  10. Zyxel Zyxel Prestige 841: Port Forwarding

    in XboX Networking Hardware
    Zyxel Zyxel Prestige 841: Port Forwarding: Zyxel (Modems/Gateways) Zyxel Prestige 841: Port Forwarding Login Information To login and configure the P-841 you will need a computer with terminal emulation software configured. You will also...